Good Screws truly fill a void in the market place.” Cleaner, straighter, and the heads don’t break off on double layer!” “ Good Screws wood screws are the best by far. And, your Good Screws GS21 self-drilling framers are so much better than other brands that it is amazing.” “I had one of my most trusted workers perform a blind test on the screws and it was determined that the Good Screws sharp point board screws increased production by 10% or more when compared to three other brands we have used in the past. After using the Good Screws in the field those problems are gone. They have been using #10 framing screws or hex heads in lieu of a #8 screw, when not required by specs, just to overcome the dull screws. Hence, the automatic default to use tek screws for 30 mil and 33 mil studs, even for the EQ versions. Dull screws are encountered and quality is what it is. “I queried every person on my crew and it was apparent that everyone expects screws to periodically fail or perform poorly. Good Screws are much better than any of the alternatives.” We are glad they are back and available to us. He reported that Good Screws were definitely far superior to all of the others.” I instructed him to do the following: Install samples of each brand's wafer-head self-drillers into 14 GA track and studs. “I had one of my best guys blind test Hilti, Grabber and Pro-Twist screws against Good Screws. I have recommended Good Screws to the other foremen, and the entire company.” Now the crew is happy and we are getting much better production. We were using Hilti, and my guys were not happy. “I was thrilled to get Good Screws back on my job. They complain if I send any other brand to the jobsite.” “The field guys love Good Screws in both bulk and collated, sharps and drillers. The Good Screws virtually stopped the stripping. The sheetrock is blamed as being too hard, then the board manufacturer blames the studs, and the stud manufacturer blames the screws. ![]() ![]() ![]() “Screw stripping in light gauge metal has been a big problem for years. We have had much better luck with Good Screws. They were dull and didn’t fit onto the bit tip very well, so we would end up with a lot of screws on the floor. “The self-tapping framing screws we were previously using were garbage. ( NOTE: Tell us your own Good Screws Experience here.)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |